![how to install usb mass storage device driver windows xp how to install usb mass storage device driver windows xp](https://www.windowscentral.com/sites/wpcentral.com/files/styles/large/public/field/image/2015/03/USB-for-mobile-WIndows-10.png)
To clean up, select the HKEY_LOCAL_MACHINE\temp key and unload the hive over the File menu. With the path of the CurrentControlSet in the loaded hive that you have determined above(replace ControlSet001 with your active Set):Īfter importing the files open regedit.exe again and check if the keys are imported at the right place. HKEY_LOCAL_MACHINE\System\CurrentControlSet notepad.exe)and replace all Registry Pathes: The registry pathes in the regfile must be changed prior. It is not possible to import the reg files directly because they would only modify the Windows PE Registry. Note the active ControlSet.īoth registry files must be imported now. Is the CurrentControlSet of the Windows installation. for example “Current”=1 means HKEY_LOCAL_MACHINE\temp\ControlSet001 The Value “Current” points to the ControlSet which is active. To check which is the active path navigate to HKEY_LOCAL_MACHINE\temp\Select. To HKEY_LOCAL_MACHINE\System\ControlSet001 or 002 at runtime.
HOW TO INSTALL USB MASS STORAGE DEVICE DRIVER WINDOWS XP DOWNLOAD
If loaded, locate the active ControlSet of Windows.īackground: HKEY_LOCAL_MACHINE\System\CurrentControlSet is only a link This page contains the driver installation download for USB Mass Storage Device in supported models (1AAAA000) that are running a supported operating system. One possible cause of USB Mass Storage Device problems: Windows can get confused by all the old (and sometimes conflicting) USB storage driver data that tends to collect and remain installed on a PC. Under the HKEY_LOCAL_MACHINE\temp Key of the running Windows PE and you can make some changes to it. Starting from now the HKEY_LOCAL_MACHINE\System Registry Path of the installed Windows is available In the Registry Editor select HKEY_LOCAL_MACHINE, open the file menu, click “Load Hive”Īnd navigate to System Hive of the Windows on disk select C:\WINDOWS\system32\config\SYSTEM, open it and give the key a name, for example “temp”. Now you have to load the System Registry Hive of the Windows Installation. The Driver file (.sys) itself must be stored in %Systemroot%\system32\drivers.The masstorage device driver is registered in Windows at five positions: It is possible to correct this and respective, if the hardware changed, to add a driver manually. If a Windows boot ends with a bluescreen STOP 0x0000007B INACCESSIBLE_BOOT_DEVICE, the system is unable to load a driver for your disk controller properly. This posts describes which steps are necassary to add or repair a masstorage driver in an exiting Windows installation.